Besides typical machine screw setter specifications, the Handy accepts various kinds of work shapes by machining the jaw shapes, installing workpiece jigs, and machining the Y pipe shapes.
- A No tightening space for the jaws.
Machine a wider groove to match the workpiece.
- B No tightening space for the jaws.
Machine away part of the jaws.
- C Protrusions on both sides of workpiece screw tightening section (Can't attach Locker).
Use a custom long-type jaw.
- D Tip of standard jaw sticks in groove or hole and won't open.
Use an angled jaw.
- E Jaw tip does not reach screw hole.
Use a pipe jig.
- F Y pipe interferes with the workpiece.
Use a pipe jig.
- G Hole in workpiece for screw-tightening is too deep and narrow.
Use a long stroke type bit.
- H Worried about scratching workpiece with jaws.
Use an L type or straight jig.
- I There is ahigh step next to the tightening section.
Use a long-nose type or step-type so the Y pipe does not strike the side of the workpiece.
Typical Examples
- Screws smaller than minimum length
- When screw length is smaller than the standard minimum length shown on pages 1 and 2, tighten by fitting on a Guide piece in the Y pipe.
-
- Nipple temporary-tightening fastener
- Nipple temporary-tightening jobs can be done by just machining the driver bit. Use for bicycle and motorcycle assembly jobs.
Typical models #13-40S #9-40S #14-40S #10-40S #15-40S #11-40S Usable nipples Screwhead diameter Screw Shank Bicycle nipples #13 φ7 φ4.3 Bicycle nipples #14 φ6.5 φ4 Bicycle nipples #15 φ6.5 φ4 Motorcycle nipples #6 φ12 φ8.4 Motorcycle nipples #8 φ11 φ7 Motorcycle nipples #9 φ9.5 φ6.5 Motorcycle nipples #9新 φ10 φ6.5 Motorcycle nipples #10 φ9 φ5.8 Motorcycle nipples #10新 φ9.5 φ5.8 Motorcycle nipples #11 φ8 φ5
* Push-start is a 40s.
* Available for any 35A (lever start)
